Processor
For a list of available processors, see
Computer major components on page 4
1.
Prepare the computer for disassembly (
Preparation for disassembly on page 18
).
2.
Remove the access panel (
3.
Remove the air duct (
).
4.
Remove the fan sink (
).
5.
Pull the locking lever away from the processor socket (1).
6.
Rotate the locking lever to its full open position (2).
7.
Raise and rotate the microprocessor retainer to its fully open position (3).
8.
Lift the processor (4) straight up and remove it.
IMPORTANT:
Remove heat sink retaining screws in diagonally opposite pairs (as in an X) to even the
downward forces on the processor. This is especially important as the pins on the socket are very fragile,
and any damage to them could require replacing the system board.
The heat sink must be installed within 24 hours of installing the processor to prevent damage to the
processor’s solder connections.
NOTE:
After installing a new processor onto the system board, always update the system ROM to ensure
that the latest version of the BIOS is being used on the computer. The latest system BIOS can be found on the
Web at:
Processor
59
Summary of Contents for EliteDesk 800 G5
Page 1: ...Maintenance and Service Guide HP EliteDesk 800 G5 SFF ...
Page 4: ...iv Safety warning notice ...
Page 9: ...Index 139 ix ...
Page 10: ...x ...
