HP 635n, Administrator'S Manual

Page: 136 / 194

Message Description
IPv4 Section
The following table includes items displayed under the IPv4 section of the configuration page.
Table 8-6 IPv4 Section
Message Description
IP ADDRESS: The Internet Protocol version 4 (IPv4) address assigned to the HP Jetdirect print
server. This is a required entry for operation of the print server on a TCP/IP network.
During initialization, a temporary value 0.0.0.0 is displayed. After two minutes, a
default IP address 169.254/16 or 192.0.0.192 is assigned.
Not Specified: Indicates that an IP address is not assigned or the value is zero.
SUBNET MASK: The IPv4 subnet mask configured on the HP Jetdirect print server. During
initialization, a temporary value 0.0.0.0 is displayed. Depending on configuration
parameters, the print server may automatically assign a usable default value.
Not Specified: Indicates that a subnet mask is not configured.
DEFAULT GATEWAY: The IPv4 address of the gateway used when sending packets off the local network.
Only one default gateway may be configured. During initialization, a temporary value
0.0.0.0 is displayed. If not provided, the IP address of the Jetdirect print server is
used.
Not Specified: Indicates that a default gateway is not configured.
CONFIG BY:
Identifies how the HP Jetdirect print server obtained its IPv4 configuration:
BOOTP: Automatic configuration through a BOOTP server.
BOOTP/TFTP: Automaticautomatic configuration through a BOOTP server and
TFTP configuration file.
DHCP: Automatic configuration through a DHCP server
DHCP/TFTP: Automatic configuration through a DHCP server and TFTP
configuration file.
RARP: Automatic configuration through the Reverse Address Resolution Protocol.
USER SPECIFIED: Manual configuration through Telnet, the printer's control panel,
HP Web Jetadmin, embedded Web server, or other method.
DEFAULT IP: The default IP address was assigned. This address may not be a valid
address for your network.
AUTO IP: A link-local IP address (169.254.x.x) was assigned. If the network is a link-
local network, this address should be valid.
NOT CONFIGURED: The print server was not configured with IP parameters. Verify
that TCP/IP is enabled, or check for error status.
BOOTP SERVER:
or
DHCP SERVER:
Displayed if BOOTP, DHCP, or RARP is used for TCP/IP configuration. It specifies
the IP address of the system that responds to the HP Jetdirect print server's request
for automatic TCP/IP configuration over the network.
Not Specified: Indicates that the configuration server's IP address could not be
determined or was set to zero in the response packet.
Table 8-5 TCP/IP Configuration Information (continued)
126 Chapter 8 HP Jetdirect Configuration Pages ENWW