HP 635n, Administrator'S Manual

Page: 132 / 194

Message Description
I/O CARD INITIALIZING, or INITIALIZING: The HP Jetdirect print server is initializing
the network protocols. For more information, see the status line for each protocol on
the configuration page.
I/O CARD NOT READY, or ERROR: There is a problem with the print server or its
configuration.
An error code and message is displayed if the print server is not ready. For more
information, see
Table 8-12 Error Messages .
MODEL NUMBER: The model number of the HP Jetdirect print server (for example, J7961A)
HARDWARE ADDRESS: The 12-digit hexadecimal network hardware (MAC) address of the HP Jetdirect print
server installed in the printer or device. This address is assigned by the manufacturer.
FIRMWARE VERSION: The firmware revision number of the HP Jetdirect print server currently installed in
the printer.
LAA The Locally Administered Address (LAA) identifies the user-specified LAN hardware
address of a print server, which may be required by some network adiministrators.
The default address is the print server's factory-default LAN hardware address.
PORT CONFIG: Identifies the link configuration of the RJ-45 port on the HP Jetdirect wired Ethernet
print server:
10BASE-T HALF: 10 Mbps, half-duplex
10BASE-T FULL: 10 Mbps, full-duplex
100TX HALF: 100Mbps, half-duplex
100TX-FULL: 100Mbps, full-duplex
1000T-FULL: 1000 Mbps, full-duplex
UNKNOWN: The print server is in an initialization state.
DISCONNECTED: A network connection has not been detected. Check network
cables.
AUTO NEGOTIATION Identifies whether IEEE 802.3u Auto-negotiation on the HP Jetdirect 10/100/1000–T
port is enabled (ON) or disabled (OFF).
ON (default): The HP Jetdirect print server will attempt to automatically configure
itself onto the network at the proper speed (10, 100, 1000 Mbps) and mode (half or
full duplex). Auto-negotiation is enabled after a cold reset.
OFF: You must manually configure the speed and mode using the EIO menu from
the printer's control panel. If Auto-negotiation is off, the settings must match those of
the network for proper operation.
MANUFACTURING ID: The manufacturing identification code for use by HP online support personnel.
S/N: The serial number of the HP Jetdirect print server.
DATE MANUFACTURED: Identifies the date of manufacture of the HP Jetdirect print server.
Security Settings
Information in this section of the Jetdirect configuration page is described in Table 8-3 Security
Settings .
Table 8-2 HP Jetdirect Configuration (continued)
122 Chapter 8 HP Jetdirect Configuration Pages ENWW