HP 635n, Administrator'S Manual

Page: 56 / 194

general Disables the Advanced commands. Help (?) will not include Advanced commands
(default).
save Save the configuration values and exit the session.
exit Exit the session.
export Export the settings to a file for editing, and importing through Telnet or TFTP (this
command is only supported by systems, such as UNIX, that support input/output
redirection).
General
passwd Set the administrator password (shared with the embedded Web server and HP Web
Jetadmin). For example, “passwd jd1234 jd1234” sets the password to jd1234. Note
that “jd1234” is entered twice for confirmation.
Up to 16 alphanumeric characters may be used. When initiating the next Telnet
session, you will be prompted for a user name and this password.
To clear the password, enter the command without password and confirmation entries.
Passwords may be cleared by a cold reset.
sys-location Alpha-numeric string (up to 255 characters), typically used to identify a location.
sys-contact Alpha-numeric string (up to 255 characters), typically used to identify the name of a
network or device administrator.
ssl-state
Sets the print server's security level for Web communications:
1 : Forced redirection to the HTTPS port. Only HTTPS (secure HTTP) communications
can be used.
2 : Disable forced redirection to HTTPS. Both HTTP and HTTPS communications can be
used.
security-reset Reset security settings on the print server to factory default values. 0 (default) does not
reset, 1 resets the security settings.
TCP/IP Main
host-name
Alphanumeric string (up to 32 characters), to assign or change the name of the network
device. For example,
“host-name printer1” assigns the name “printer1” to the device. The default host name
is NPIxxxxxx, where xxxxxx are the last six digits of the LAN hardware (MAC) address.
ip-config Specify the configuration method:
manual : The print server will wait for IP parameters using manual tools (such as Telnet,
embedded Web server, control panel, installation/management software). Status will be
User Specified
.
bootp : The print server will send BOOTP requests on the network for dynamic IP
configuration.
dhcp : The print server will send DHCP requests on the network for dynamic IP
configuration.
auto_ip : The print server will be automatically configured with a unique link-local
address 169.254.x.x.
Table 3-3 Telnet Commands and Parameters (continued)
46 Chapter 3 TCP/IP Configuration ENWW