HP 635n, Administrator'S Manual

Page: 146 / 194

Error Code and Message Description
4E CF ERR - TRAP LIST
EXCEEDED The TFTP configuration file specified too many trap destination list entries using the
“trap-destination:” keyword.
4F TFTP REMOTE ERROR The TFTP transfer of the configuration file from the host to the HP Jetdirect print
server failed with the remote host sending a TFTP ERROR packet to the print server.
50 TFTP LOCAL ERROR The TFTP transfer of the configuration file from the host to the HP Jetdirect print
server failed with the local print server encountering some form of inactivity timeout,
or excessive retransmissions situation.
51 TFTP RETRIES EXCEEDED The overall retrying of the TFTP transfer of the configuration file from the host to the
HP Jetdirect print server has exceeded a retry limit.
52 BAD BOOTP/DHCP REPLY
An error was detected in the BOOTP or DHCP reply that the HP Jetdirect print server
received. The reply either had insufficient data in the UDP datagram to contain the
minimum BOOTP/DHCP header of 236 bytes, had an operation field that was not
BOOTPREPLY(0X02), had a header field that did not match the print servers
hardware address, or had a UDP source port that was not the BOOTP/DHCP server
port (67/udp).
53 BAD BOOTP TAG SIZE The tagsize in a vendor-specific field in the BOOTP reply is either 0, or greater than
the remaining number of unprocessed bytes in the vendor-specified area.
54 BOOTP/RARP IN PROGRESS The HP Jetdirect print server is currently in the process of obtaining its basic IP
configuration information through BOOTP/RARP.
55 BOOTP/DHCP IN PROGRESS The HP Jetdirect print server is currently in the process of obtaining its basic IP
configuration information through BOOTP/DHCP, and has not detected any errors.
56 DHCP NAK
The HP Jetdirect print server received a negative acknowledgement message from
the DHCP server in response to a configuration request.
57 UNABLE TO CONNECT DHCP
SVR The HP Jetdirect print server had received IP parameters from a DHCP server, but
communication with the DHCP server has been lost. Check status of the DHCP
server.
If an infinite lease was assigned, the print server will use the IP address of the most
recent DHCP server used, but operation may be degraded until a DHCP server
responds.
58 POSTSCRIPT MODE NOT
SELECTED
The printer does not support AppleTalk or AppleTalk extensions.
59 INCOMPLETE F/W - MUST
DOWNLOAD Firmware download message. Currently downloading firmware to the HP Jetdirect
print server, or the download did not complete properly.
5A TURN PRINTER OFF / ON Firmware download message. Download of firmware is complete. Power off/on the
HP Jetdirect print server.
5C DHCP BAD REPLY A bad reply was received from the DHCP server. Check your DHCP server settings
for this print server.
5D DHCP LEASE DURATION TOO
SHORT The DHCP lease times for this print server's TCP/IP configuration settings are too
short. Reconfigure the DHCP lease times on the DHCP server.
5E DHCP LEASE RELEASED The lease for DHCP-configured parameters, including the IP address, have been
released through a manual configuration method, such as through the printer's
control panel.
5F WINS REGISTRATION FAILED Attempts to register the print server's name on the WINS server failed. Check for
duplicate names, or verify the WINS server configuration.
61 AUTO IP CONFIGURED An IP address could not be retrieved over the network. The print server will default to
an IP address using link-local addressing in the form 169.254.x.x.
Table 8-12 Error Messages (continued)
136 Chapter 8 HP Jetdirect Configuration Pages ENWW