1-14
from 2002:201:101:1::2 with 32 bytes of data:
Reply from 2002:501:101:1::2: bytes=32 time=13ms
Reply from 2002:501:101:1::2: bytes=32 time=1ms
Reply from 2002:501:101:1::2: bytes=32 time=1ms
Reply from 2002:501:101:1::2: bytes=32 time<1ms
Ping statistics for 2002:501:101:1::2:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 13ms, Average = 3ms
Configuring ISATAP Tunnel
Configuration Prerequisites
z
Configure IP addresses for interfaces (such as the VLAN interface and loopback interface) on the
device to ensure normal communication.
z
Specify one of the above interfaces as the source interface of the tunnel.
z
Ensure reachability between the tunnel source and destination addresses.
Configuration Procedure
Follow these steps to configure an ISATAP tunnel:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enable IPv6
ipv6
Required
By default, the IPv6
forwarding function is
disabled.
Create a tunnel interface and enter
tunnel interface view
interface tunnel
number
Required
By default, there is no tunnel
interface on the device.
ipv6 address
{
ipv6-address prefix-length
|
ipv6-address/prefix-length
}
Configure an
IPv6 global
unicast address
or site-local
address
ipv6 address
ipv6-address
/
prefix-length
eui-64
Required.
Use either command.
By default, no IPv6 global
unicast address is
configured for the tunnel
interface.
ipv6 address auto
link-local
Configure an
IPv6 address for
the tunnel
interface
Configure an
IPv6 link-local
address
ipv6 address
ipv6-address
link-local
Optional
By default, a link-local
address will automatically be
generated when an IPv6
global unicast address or
link-local address is
configured.
