horsch Maestro CX, Translation Of The Original Operating Instructions

Page: 51 / 184

Operation | 6
60013444 • 01 • 01/2021 • en 51
Parking the machine
unfolded
1. Position the machine at a suitable location, unfold and set the tractor brake.
2. Apply the parking brake (option).
3. Secure the machine with wheel chocks against rolling away. Position the
wheel chocks under the side of the tyres pointing to the downward slope.
4. Lift the seed bar.
5. Remove the clips from the hydraulic cylinders on the undercarriage.
6. Place trap rollers in parking position.
7. Lower the seed bar completely.
8. Direct the bottom plate on the support downward. Secure the pin with the
cotter pin.
9. Crank down the support.
10. Unplug the brake lines, ISOBUS and lighting and hook in the bracket. Attach
the covering caps.
11. Depressurise the hydraulic lines and disconnect them.
12. Unhitch the machine.
Machines with drawbar eye:
• Adjust the height of the drawbar by cranking the support so that the machine
can be picked up.
• Engage the machine.
• Insert the bolts and secure them.
Machines with ball and socket coupling:
• Lower the drawbar or spherical cap onto the ball by cranking on the support.
• Position the hold-down.
• Check the gap between hold-down and spherical cap and adjust; see chapter
Maintenance overview .
Machines with tractor link arm:
• Release the securing device of the catching hooks.
• Lower the tractor link arm.
13. Drain the air reservoir of the pneumatic brake system (option)
14. Clean the metering units.
15. Close the hopper covers.
16. Store the terminal in dry conditions.
NOTE
When parking, the trap rollers must not rest on the ground. They would otherwise
shortly be out of order because of resting damages.
Ø
You should either support the frame high enough, or disassemble the trap
rollers and insert them into the bracket from above, see chapter "Trap roller".