Honeywell Rapid Eye Hybrid LT, Installation Manual

Page: 55 / 86

Rapid Eye™ Hybrid LT DVR Installation Guide
Document 800-07766V4 Rev A 55
01/2013
Figure 5-2 Pin Order on Serial Ports 3 and 4 of an RJ45 Connector
Hardware Options
A Rapid Eye Hybrid LT DVR interfaces with hardware such as:
•
Public display monitor (see the next section).
• Cameras, and domes that pan-tilt-zoom (PTZ). See Connecting a PTZ Dome , page 56 .
• Alarm sensors, connected to a Rapid Eye Hybrid LT DVR’s inputs. See Inputs for
Sensors , page 59 .
• Relay triggered devices, including locks, gates, warning sirens, and so on, that
connect to the outputs of a Hybrid LT DVR. See
Control Outputs , page 61 .
• Relay triggered device for system monitoring. See System Monitoring , page 61 .
• Point-of-sale hardware, with text messaging over serial communications, or any other
device with serial communication capability. See
Point-of-Sale Hardware , page 63 .
Public Display Monitor
A public display monitor can be set up on Hybrid LT DVRs, independently of LocalView.
There is no need for converters between the monitor and the DVR.
Note The public display monitor will not display video from IP cameras. Use
LocalView and/or the Remote View application to view/playback video from
Honeywell and/or supported ONVIF IP cameras.
Table 5-2 Wiring an RJ45 Cable for Serial Use
RS485 (half duplex)
GND - 4
+DX - 1
-DX - 2