Honeywell Rapid Eye Hybrid LT, Installation Manual

Page: 37 / 86

Rapid Eye™ Hybrid LT DVR Installation Guide
Document 800-07766V4 Rev A 37
01/2013
Common Network
Figure 2-7 LocalView Panel for Network Settings
If you are not using Dynamic Host Configuration Protocol (DHCP), enter the IP Address for
your unit manually:
1. Using LocalView, enter the
IP Address of the DVR (see Figure 2-7 ). Click to open
the virtual keyboard (see Figure 2-6 ). Click the keyboard buttons to enter the IP
Address and click OK .
2. Click Enter .
Dynamic Host Configuration Protocol Using DNS
Figure 2-8 LocalView Network Settings with DHCP
If you are using Dynamic Host Configuration Protocol (DHCP) to assign an IP Address for
your unit, select the
Use DHCP check box:
1. In Network Settings, enable DHCP on the Rapid Eye Hybrid LT unit (see Figure 2-8 ).
By default, the Site Name in LocalView shows
REM[hyphen][DVR serial
number]
and includes the leading zeroes. The DVR serial number is also printed on a
sticker affixed to the DVR.
If you change the Site Name, make a note of the new name, for setting up a remote
connection using the Admin software.
2. Click Refresh .