Honeywell Rapid Eye Hybrid LT, Installation Manual

Page: 29 / 86

Rapid Eye™ Hybrid LT DVR Installation Guide
Document 800-07766V4 Rev A 29
01/2013
Note Rapid Eye Hybrid LT DVRs support up to 4/8 Honeywell equIP
®
V2, equIP
®
H.264, equIP
®
1080p, equIP
®
Wide Dynamic Range IP, Performance IP,
and/or HD3/4 IP cameras on Rapid Eye Hybrid LT V10.1 units. Some ONVIF
IP cameras are also supported (see
http://www.security.honeywell.com/hota
for a complete list of IP cameras supported by Rapid Eye Hybrid LT V10.1 and
V10.0 DVRs).
Caution Power down the DVR before connecting hardware to it. See Powering the
Hybrid LT DVR on page 30 for more information.
Figure 2-2 Analog Camera Connections to a Hybrid LT DVR
Connect the analog cameras sequentially; that is, connect the first camera to VIDEO INPUT
1, the second camera to VIDEO INPUT 2, and so on.
The BNC connector’s low signal loss, ease of twist-on installation, and small size, make it
a common connector for CCTV connections. Honeywell recommends using a solder- or
crimp-type connector.
Video is quite sensitive to bad connectors; do not use screw-type connectors. These can
seriously compromise the performance of your DVR.
Note If you are using Honeywell and/or supported ONVIF IP cameras in your
system, you must decide what channels you want the IP camera(s) to use
(Video Input 1, 2, or 3, and so on). Make sure the video input connections on
the back panel for the chosen channel(s) are not being used by any analog
cameras if they are going to be used for IP cameras.
1 2
S ERIAL PO RT 2
S ERIAL PO RT 1 V GA
TE LCO
US B USB
LAN
IN
OU T
N OT
U SE D
1 2 3 4 5 6 7 8
SPOT
MONITOR
VIDE O
IN PUTS
COMMON
SYS FAIL
SYS GOOD
F AULT
RELAY
28V, 3A
MAX
1 G G G G 2 3 4
CON TROL
OUT PUTS
SE RIAL
POR T 3
SE RIAL
POR T 4
1 G G G G 2 3 4 5 G G G G 6 7 8
ALA RM INPUTS
ON/OFF
POW ER
115-230V ~
50/60 Hz
5-3A
8-channel Rapid Eye Hybrid LT unit