LYNX Touch Installation and Setup Guide
- 41 -
Programming the Control
Program Reporting (Continued)
Notes:
If applicable, preprogrammed defaults for the L5200/L7000 Control are shown on the screen unless otherwise noted.
When GSM is used as the Primary Communications channel for any Total Connect service, the GSM Radio must be
selected as the Primary Reporting Path (Preferred Radio).
SCREEN ACTION
Reporter
Select “Reporter”
The System displays the following options:
Primary CS Info
Secondary CS Info
Follow Me Phone 1*
Follow Me Phone 2*
Report Selection
Options
Downloader
Note:
The Follow Me feature is not available on the LYNX Touch L7000 Series controls.
Primary CS Info
Select “Primary CS Info”. The System displays the following options:
Phone Type
Communicator Type
Phone Type
Contact Id: 4 Digit
Select “Phone Type”. The System scrolls though the following options:
None
Contact Id: 4 Digit
Contact Id: 10 Digit
SIA
Communicator Type
None
Select “Communicator Type”. The System scrolls though the following options:
None
GSM
WiFi
WiFi & GSM
IP
Note:
The system will display the communications (GSM, WiFi or IP) paths based on the selection
made in Communicator Programming. The Communication Path selection can be enabled for
either Primary Central Station or Secondary Central Station but not both. If it is enabled in one it
will not be available for the other Central Station. If APL is used, GSM, WiFi or IP must be
selected as the Primary Communicator Type.
Phone Number
If any option other than “None” is selected in “Phone Type” The “Phone Number” option will
be displayed. Select “Phone Number”. Enter the Primary Central Station Phone Number on
the displayed keypad. (Up to 20 digits)
Account Number
FFFF
If any option other than “None” is selected in “Phone Type” The “Account Number” option
will be displayed. Select “Account Number”. Enter the Primary Central Station Account
Number on the displayed keypad.
Dynamic Priority
Redundant Reports
If any option other than “None” is selected in “Communicator Type” The “Dynamic Priority”
option will be displayed. “Select “Dynamic Priority”. The system scrolls between “Redundant
Reports”, “Preferred Telco” and Preferred Radio”.
Dynamic Delay
30 Seconds
If any option other than “Redundant Reports” is selected in “Dynamic Priority” The “Dynamic
Delay” option will be displayed. “Select “Dynamic Delay”. The system scrolls between “15
Seconds”, “30 Seconds”, “60 Seconds” and “90 Seconds”.
Note:
If GSM is selected as the primary reporting channel Dynamic Delay should be set to minimum
of 60 seconds.
Report All
Press to Report All
Select “Report All”. The System toggles between “Press to Report All” and “Report All Set”.
If “Report All” is selected all reporting options will be “Enabled”. Select the “Save” key to
return to the Reporter options screen.
Report Alarms
Enabled
Select “Report Alarms”. The System toggles between “Disabled” and “Enabled”.
SIA:
The L5200/L7000 Touch default is “Enabled”.
Report Troubles
Enabled
Select “Report Troubles”. The System toggles between “Disabled” and “Enabled”.
SIA:
The L5200/L7000 default is “Enabled”.
Report Open/Close
Disabled
Select “Open/Close”. The System toggles between “Disabled” and “Enabled”.
Report Tests
Enabled
Select “Report Tests”. The System toggles between “Disabled” and “Enabled”.
SIA:
The L5200/L7000 default is “Enabled” and is not selectable.
