LYNX Touch Installation and Setup Guide
- 24 -
Mechanics of Programming
Loading Factory Defaults
To load the factory defaults, enter the Installer Programming Mode and advance to second page of the
System Programming and refer to following procedure. Refer to the Programming Default Values section of
this manual to view the Default Values.
If a default configuration is loaded, any data that has already been programmed into the system will be
changed according to the default configuration selected!
Select a Default Configuration
SCREEN ACTION
System Programming...
5100-100-060-
V
0
System Settings
So
u
nder
Reset Master Code
Lang
u
age
Z-Wa
v
e
Defa
u
lt Config.
1. Select “Default Configuration” to display the following options:
Default Config 1
Default Config 3
Default Downloader
Default Config 2
Default Config 4
Note:
For a list of the pre-programmed defaults refer to the
Default Values section.
2. Select the desired Default Configuration.
3. A Confirmation screen is displayed.
4. If “Yes” is selected, the System beeps three times and returns
to the Default option screen.
5. If “No” is selected, the System returns to the Default option
screen.
Exiting Program Mode
1. Select the “
” key to exit the current screen. The system returns to the previous screen.
2. Select the “
” key as required until system displays a Confirmation screen.
3. Select “Yes” to allow the installer to re-enter Programming mode or “No” to prevent re-entry.
4. Select the “
” key again to return to the Security Screen OR depress the Home button to return to the
Home Screen.
