Honeywell HD6 Series, User Manual

Page: 21 / 152

Rev. 1.02 7 900.0679
22-June-2006
2.2 RECEIVER BOARD SETTINGS, continued
2.2.1 Defining Protocol (Switches 1-4)
Protocol 1 2 3 4
Honeywell Diamond OFF OFF OFF OFF
Honeywell VCL ON OFF ON OFF
Honeywell Maxpro
Mode ON OFF OFF OFF
MUX100 OFF ON OFF OFF
AD ON ON OFF OFF
Pelco P OFF OFF ON OFF
Pelco D OFF ON ON OFF
Pelco P_AD OFF OFF ON ON
Pelco D_AD OFF ON ON ON
Equipment Protocol
Javelin equipment Set the Javelin controller for Diamond protocol and
set the HD6 unit for Honeywell Maxpro Mode
protocol.
HD6 with an AD1281/1 Code
Distributor Set the HD6 to American Dynamics protocol.
HD6 with a Sennetech Code
Translator, Model SCT-1036 Set the HD6 to Honeywell Maxpro Mode protocol.
HD6 with the Digital Interface Set the HD6 protocol to Honeywell VCL if using with
Honeywell’s DVM Digital Video Manager. Set the
HD6 to standard (Honeywell Diamond) protocol
when controlling the dome with a web browser.
NOTE: If the switches are set to something other than the above settings, the scan
defaults to Honeywell Diamond protocol.
The standard Pelco P and D selections use special PreShots numbered in
the 80’s and 90’s. The Pelco P w/AD PreShots and the Pelco D w/AD
PreShots selections set the protocol for Pelco P and Pelco D code
respectively, but use special PreShot numbers less than 32 for HD6 menus
and setup.