Honeywell HD6 Series, User Manual

Page: 53 / 152

5.4 DIAGNOSTIC OPTIONS, CONTINUED
5.4.5 Display Error Table Codes
Rev. 1.02 39 900.0679
22-June-2006
Select 5 to display a list of the error and
event table codes. When using the HJZTP
controller, use the F1 (
S
), F2 (
T
), F3 (
W
),
and F4 (
X
) keys to scroll through the list.
Select Esc (F6 on HJZTP controller ) to exit
the list.
If the scan receives a 00 corrupted memory
error code, the scan automatically clears
the memory and resets all default settings.
All user programming (PreShots,
VectorScans, Sector IDs, and Privacy
Zones) is deleted.
Error and Event Codes:
00 – Corrupted memory
01 – Proc low voltage reset
02 – Proc bus error
03 – Proc address error
04 – Proc illegal instruction
05 – Proc zero divide
06 – Proc privilege violation
07 – Proc spurious interrupt
08 – Four ESC reset
09 – Pan motor error
10 – Corrupted data to camera
11 – Camera data queue
overrun
21 – Command queue overrun
22 – Packet framing error
C0 – Receive queue overrun
Cx – bit0 - Byte parity error
bit1 - Byte framing error
bit2 - Byte noise error
bit3 - Byte overrun error
D0 – Byte timeout error
D8 – Packet parity error
EE – RESET, following byte
gives type of reset:
bit1 - System Reset
bit2 - Loss of Clock Reset
bit4 - Bus Fault Reset
bit5 - Watchdog Reset
bit6 - Power ON Reset
bit7 - External Reset
In the Cx code the last hexadecimal digit is
made up as follows:
bit#
3 2 1 0 hexadecimal digit
0 0 0 0 0
0 0 0 1 1
0 0 1 0 2
0 0 1 1 3
0 1 0 0 4
0 1 0 1 5
0 1 1 0 6
0 1 1 1 7
1 0 0 0 8
1 0 0 1 9
1 0 1 0 A
1 0 1 1 B
1 1 0 0 C
1 1 0 1 D
1 1 1 0 E
1 1 1 1 F
Therefore, this error code can represent multiple errors.
The EE error code includes the following byte (2 digit) hexadecimal number where the
right hand digit is represented as in the above table and the left hand digit is represent-
ed as in the above table with bit 0 = bit 4, bit 1 = bit 5, bit 2 = bit 6, and bit 3 = bit 7.