Honeywell AlarmNet IGSMV, Installation And Setup Manual

Page: 32 / 64

IGSMV / IGSMVCN Installation and Setup Guide
3-12
PROMPTS
ZONE
TRIG.
4204/
2-4204
ENTRY OPTIONS DESCRIPTION
5
Change
Password?
Y/N_
 
[Y], [N] If a password has already been assigned, this
prompt appears after pressing [N] at the
"Program Device?" prompt.
Press [Y] if you want to change the password.
NOTE: To clear an existing password, without
entering a new one, answer [Y] to the "Change
Password?" prompt, then press the [Enter] key
when prompted for the new password and its
confirmation.
6
Enter Password
 
[0-9, A-F,
N, S, T, X,
Y]
This prompt is displayed if [Y] was pressed in
Prompt 4 or 5.
Enter a 4-digit password (0-9, A-F, N, S, T, X,
Y).
7
Verify Password
 
[0-9, A-F,
N, S, T, X,
Y]
Re-enter the password as confirmation.
If the password doesn't match the first entry,
the following is displayed followed by the "Exit
Prog. Mode?" prompt:
Verify Not OK
PSWD not created
Otherwise, the "Exit Prog. Mode?" prompt is
displayed directly.
8
Exit Prog. Mode?
Y/N_
 
[Y], [N]
[ESC] Exits program mode.
Press [N] to go back to Prompt 3.
Press [ESC] to load factory defaults.
Refer to the Exiting Programming Mode
paragraph in this section.
9
Device Mode
(ECP)_
 
 ECP
 Zone
Trig.
 4204
Emu

Two
4204s
Press the [space] key to scroll through the
modes of operation.
Press [ENTER] to select mode.
Use Table 3-2 for ECP mode programming.
Important Information Regarding Multi-Mode
In Zone Trigger mode, the options for Multi-Mode are "Enabled" or "Disabled." If enabled, whenever a zone on the
communication device is triggered, a corresponding email message is sent INSTEAD of normal central station
reports.
Cover tamper will send email event 8. All communication device system events (such as power loss, low battery,
etc.) are still sent to AlarmNet.
Events used to send email messages are defined on the Honeywell Total Connect web site, and must correspond to
events triggering the hardwired zones.
Multi-Mode (email notification) is intended as a convenience for the user, and does not replace Central Station
reporting of critical events (alarms, troubles, etc.).
UL
Multi-Mode has not been evaluated by UL.
10
Multi Mode
(Disabled)_

 Enabled
 Disabled
Enable if you want system events sent by email
to the user.
Disable for normal alarm processing.
Important Information Regarding Primary Account (Questions 11-13)
Account information is provided by the central station administrator.
11
Primary City ID
(??)_
 
[01-99]
Enter the 2-digit primary city ID, 01-99
(decimal).
12
Primary CS ID
(???)
 
[01-FE]
Enter the 2-digit primary central station ID
number, 01-FE (HEX).