Honeywell AlarmNet IGSMV, Installation And Setup Manual

Page: 14 / 64

IGSMV / IGSMVCN Installation and Setup Guide
2-4
8. Replace lower printed circuit board and then daughter card, as shown in Step D above.
Be sure to engage receptacle pins by pushing in before securing the daughter card with
mounting screws.
When all wiring is completed, attach the case front. Position the top first, then press the
bottom section until it snaps in place. Secure bottom using the supplied cover screw. (Refer
to Figure 2-1.)
Wiring the IGSMV
UL

Installation must be in accordance with; the National Electrical Code, UL681 Installation and
Classification for Burglary and Hold-Up Alarm Systems, and UL827 for Central-Station Alarm
Services.

IGSMV must be connected to a UL Listed dry contact or voltage trigger outputs of a UL Listed
compatible control unit.

All interconnecting wires between the UL Listed control panel and the IGSMV must be less than 3 feet
in length contained in the same room. All interconnecting wiring must be installed in rigid or EMT
(where exposed on interior walls) or in flexible metal tubing if run in the walls or ceiling.

A UL listed control panel must monitor the radio fault output of the IGSMV. Premises openings and
closings should be sent via the UL listed control panel.

Only ECP mode and Zone Trigger mode have been evaluate by UL.
ULC
For ULC Commercial Fire and Burglary installations, use ECP wiring in Figure 2-8 only.
Connecting and Routing the Audio Cable
The IGSMV requires an optional audio cable (GSMV-AUDIO) to support two-way voice using
the AVS Base Unit. Note the AVS Base Unit is part of Honeywell’s AVS Audio Verification
System. This system consist of the AVS Base Unit, Remote Station, and the Remote Station
PC board. For detailed information, please refer to the AVS Audio Verification System
documentation.
Follow the guidelines below for connecting the audio cable.
1. Power down the control panel and AVS Audio Verification System. (When the IGSMV is
fully wired up, restore power to the control panel and AVS Audio Verification System.)
2. At the IGSMV, remove two [2] screws and standoff that secure the small PC board, and
swing up.
FOR
EXTERNAL
ANTENNA
50 OHM,
MMCX
ONLY
7720P
PROGRAMMER
PORT
NOT
FOR
TELEPHONE
SERVICE
USE!
PRIMARY
POWER
: 9 - 1
6 .5 V
AC
BATTERY:
6V. 3.1
AHr FOR
24 Hr
BACKUP
FCC
ID: GIPMC56IC:
Y26
7W -
MC56
G
S
M
G
P
P
S
W
E
B
M
O
D
E
2
M
O
D
E
1
R
S
S
I
Honeywell
R
X
T
X
MAC
LABEL
HERE
TRANSMIT
LED
A
UDCBL-002-V0
FOR
EXTERNAL
ANTENNA
50 OHM,
MMCX
ONLY
7720P
PROGRAMMER
PORT
NOT
FOR
TELEPHONE
SERVICE
USE!
PRIMARY
POWER
: 9 -
16 .5
VAC
BATTERY:
6V.
3.1 AHr
FOR
24 Hr
BACKUP
FCC
ID: GIPMC56IC:
Y26
7W
- MC56
GSM
GPPS
WEB
MODE 2
MODE 1
RSSI
Honeywell
RX
TX
MAC
LABEL
HERE
TRANSMIT
LED
3. Connect one end of the audio cable to the audio connector located on the small PC board.