Honeywell AlarmNet IGSMV, Installation And Setup Manual

Page: 18 / 64

IGSMV / IGSMVCN Installation and Setup Guide
2-8
Power Connections and Options
Powering the Communication Module
There are three ways to power the communications module (see Figure 2-8 below):
Standard Installation – The communications module is powered by the supplied AC plug-
in transformer.
ULC Commercial Fire and Burglary Compliant Installation – The communications
module must be powered by the control panel.
Shared Transformer Installation – In this installation the supplied AC plug-in
transformer may be used to power both the communications module and the control panel
under the following conditions:
 You must use the Honeywell 1361 Transformer.

This configuration ONLY applies to the VISTA-10P, VISTA-15P, VISTA-20P control
panels when used with the GSMV or IGSMV Communications Module.
 DO NOT use this configuration with any other control panel.
 DO NOT use this configuration if using two-way voice.
 This configuration has not been evaluated by UL.
For all installations the control panel ground (GND) must be connected to TB1-4 GND on the
communications module. In addition, if using ECP communication, you must connect the
+12VDC AUX voltage output on the control panel (9.6V-13.8V typical) to TB1-3 on the
communications module.
iGSMBR-013-V0
12V AUX
GND
COMMUNICATIONS
MODULE
CONTROL PANEL
GND
ECP (+) VOLTAGE INPUT
2
1
4
3
TB1
TRANSFORMER
AC INPUT 2
AC INPUT 1
J1
BATTERY
COMMUNICATION MODULE
CONTROL PANEL
comm_mod-001-V1
GND
ECP DATA OUT
ECP DATA IN
ECP (+) VOLTAGE INPUT
GND
DATA IN
BLK
YEL
GRN
RED
DATA OUT
+12 V AUX
2
6
1
4
5
3
TB1
NO CONNECTION
J1
AC INPUT 2
AC INPUT 1
NO CONNECTION
NO CONNECTION
NOTE: DO NOT CONNECT THE COMMUNICATION
MODULE BACKUP BATTERY OR TRANSFORMER
FOR COMMERCIAL FIRE & BURGLARY INSTALLATIONS.
Standard
Installation
ULC Commercial
Fire and Burglary
Compliant
Installation