Date of Issue: February, 2005
3-8
© American Honda Motor Co., Inc.
FG110
7. COOLING FIN INSPECTION
Inspect the engine cooling fins. You should clean out any dirt
and debris if air is obstructed from flowing across the cooling
fins.
1. Loosen the 5 mm hex bolt, then remove the fan cover.
2. Remove all dirt and debris from the cooling fins.
3. Install the fan cover, and tighten the 5 mm hex bolt
securely
.
8. THROTTLE CABLE INSPECTION
Verify that the throttle trigger operates smoothly, releases
properly, and the throttle cable is undamaged. If there is
visible damage, or if the throttle lever does not operate
smoothly or release properly, repair as needed.
Check the free play at the end of the throttle lever.
Throttle Lever Free play:
5 ~ 8 mm
(3/16 ~ 5/16 inch)
If adjustment is needed, use the
Throttle Cable Adjustment
procedure below.
9. CARBURETOR ADJUSTMENT
A tachometer is required to adjust the idle speed.
1. Start the engine outdoors, and allow it to warm up to
normal operating temperature.
2. Turn the throttle stop screw to obtain a stable idle, below
the speed at which the tiller tines begin to turn.
Standard Idle Speed:
3,100 ± 200 rpm
3. Verify that the throttle lever free play is
5 ~ 8 mm (3/16 ~ 5/16 inch). If adjustment is needed, use
the
Throttle Cable Adjustment
procedure below.
10. THROTTLE CABLE
ADJUSTMENT
1. Loosen the lock nuts with a 10 mm wrench, and move the
adjuster in or out as required.
2. Tighten the lock nuts and recheck throttle lever free play.
Throttle lever free play
5 ~ 8 mm (3/16 ~ 5/16 inch)
COOLING
FINS
THROTTLE
LEVER
5~ 8 mm
(3/16 ~ 5/16 in)
THROTTLE
STOP
SCREW
LOCK
NUTS
ADJUSTER
CHOKE
LEVER
SERVICE BULLETIN #9 =>
Summary of Contents for FG110
Page 3: ...Date of Issue February 2005 American Honda Motor Co Inc...
Page 7: ...Date of Issue February 2005 1 4 American Honda Motor Co Inc FG110 NOTES...
Page 35: ...Date of Issue February 2005 4 6 American Honda Motor Co Inc FG110 NOTES...
Page 79: ...Date of Issue February 2005 11 4 American Honda Motor Co Inc FG110...
