Date of Issue: February, 2005
© American Honda Motor Co., Inc.
9-7
FG110
• PISTON RING END GAP
Put the piston ring in the cylinder and then use the piston
crown to push the ring down. This will make the piston ring
horizontal so the ring end gap can be measured.
Because the combination oil rings are used on this model,
always replace the piston rings as a set.
• PISTON PIN O.D.
• PISTON PIN BORE I.D.
• PISTON PIN-TO-PISTON PIN BORE CLEARANCE
• CONNECTING ROD SMALL END I.D.
Standard
Service limit
Top/Second
0.10 ~ 0.25 mm
(0.004 ~ 0.010 in)
0.60 mm
(0.024 in)
Standard
Service limit
7.994 ~ 8.000 mm
(0.3147 ~ 0.3150 in)
7.950 mm
(0.3130 in)
Standard
Service limit
8.010~ 8.026 mm
(0.3154 ~ 0.3160 in)
8.060 mm
(0.3173 in)
Standard
Service limit
0.010 ~ 0.032 mm
(0.0004 ~ 0.0013 in)
0.070 mm
(0.0028 in)
Standard
Service limit
7.978 ~ 7.989 mm
(0.3141 ~ 0.3145 in)
Replace if exceeding the
standard value.
Summary of Contents for FG110
Page 3: ...Date of Issue February 2005 American Honda Motor Co Inc...
Page 7: ...Date of Issue February 2005 1 4 American Honda Motor Co Inc FG110 NOTES...
Page 35: ...Date of Issue February 2005 4 6 American Honda Motor Co Inc FG110 NOTES...
Page 79: ...Date of Issue February 2005 11 4 American Honda Motor Co Inc FG110...
