Honda FG110, Manual

Page: 68 / 81

Date of Issue: February, 2005
© American Honda Motor Co., Inc.
9-13
FG110
3. Install the holder bolt [1] of the special tool in the direction as
shown.
Install the adapter [3] on the tip of the push rod [4] that is set on
the special tool.
Install the special tool on the cylinder head so that the bolt (5 mm)
[5] sets in the center of the long hole in the special tool as shown.
Tighten the bolt (5 mm) against the cylinder head cover mounting
boss by hand.
• Set the bolt (5 mm) in the center of the long hole.
• Do not tighten the bolt (5 mm) using a wrench.
4. Bring the projection on the valve lifter [1] and the rocker arm [2] to
come in contact with the cylinder head positioning ribs [3].
Bring the clearance A [4] and B [5] to be equal by moving the
valve lifter and rocker arm right and left.
While holding the valve lifter and rocker arm in the position,
tighten the holder bolt [6] by hand until it contacts the valve lifter.
Tighten the push rod [7] by hand until the adapter [8] contacts the
rocker arm.
After installing the special tool, check that the bolt (5 mm) [9] is in
the center of the long hole [10] in the tool.
NOTICE
The cylinder head cover mounting boss can be damaged by
tightening the push rod with the bolt (5 mm) not in the center but
on either side in the long hole. Be sure that the bolt is in the center
of the long hole securely.
5. Using a 14 mm wrench [1], tighten the push rod [2] until the rocker
arm [3] comes to the cylinder head cover installation part. [4]
TOOL:
Rocker arm replacement tool [2]
070PF-Z0HA100
[1]
[2]
[4]
[3]
[5]
[1]
[2]
[3]
[6]
[8]
[10]
[3]
[9]
[4]
[5]
[7]
[4]
[1]
[2]
[2]
[3]
[3]
Revised: March, 2015
© American Honda Motor Co., Inc.