39
Operation manual geodyna 2350 - 9413 126
Changing modes of operation
79
80
81
Input: Code/state
Display: Code/state
C13
0
C13
C13
+
-
to 0
+
-
to 13
+
-
to 1
XXX
XXX
222
123
Back to working mode
+
-
to 10
XXX
C10
XXX
1
+
-
to 1
+
-
to 1
C10
to 12
+
-
Back to working mode
C12
C12
1
1
Code C10
Fig. 79
Storing the selected mode of operation in the perman-
ent memory
0*
=
No storage
1
=
Data are stored in the permanent memory
D
Store in the permanent memory - a three-tone signal is
given to acknowledge acceptance.
If the mode stored in the permanent memory is to be changed,
enter the desired state (e. g. on or off) for the mode in question
and transfer it via code C10 into the permanent memory (not
possible for code C4).
Code C12
Fig. 80
Readings of numbers of measuring runs
Example: 222,123 measuring runs so far performed
By pressing the FINE key and rotating the wheel the following
counters can be displayed:
1 = Total number of measuring runs
2 = Number of measuring runs where balance quality was
considered OK
3 = Number of Pro-Match performed
4 = Number of measuring runs in service mode
5 = Number of measuring runs since the last calibration
Maximum count is 999,999 runs. Once this number is reached,
the counter is reset to zero.
Code C13
Fig. 81
Starting the mesuring run by closing of (optional)
wheel guard
0*
=
Start via START key
1
=
Start via wheel guard
The selected mode of operation can be transferred to the per-
manent memory.
* = Factory adjusted mode
