CTC-CEN Service Manual 07-13 Rev.E
82
TO REPLACE THE DISC:
Remove the plastic protection.
Remove the rollpin. Then remove the bushing.
Remove the washers and then loosen the four screws to complete the dismounting of the disc.
Mount the pin to the disc and secure the screws with Loctite. Then replace the old washers with the new ones.
Mount the disc assembly to the bead breaker arm holder.
Install the roll pin again.
Install the protection.
Check if the machine works fine again.
8.6 BEAD BREAKER DISCS # EAM0065G63A: CHECK AND REPLACEMENT
:
30’ Each one
:
Allen key 4mm.
:
Bad bead breaker disc may cause the following malfunction:
1.
Disc touches the rim during bead breaking operation.
2. The disc is broken
TO CHECK THE DISC:
Turn the machine off.
Summary of Contents for ATC 900
