CTC-CEN Service Manual 07-13 Rev.E
84
Install the new bearing with loctite to the support.
Tighten the 12mm screw firmly.
Tighten again the lateral set screw.
Mount again the bead breaker disc.
Turn the machine and perform the bead breaker discs alignment calibration (
6.5).
Turn the machine on and check if it works fine
8.8 BEAD BREAKER DISCS INCLINATION ADJUSTMENT
:
30’ each one
:
Allen keys 4 and 5, electronic inclinometer.
:
Incorrect bead breaker discs inclination may cause the following malfunctions:
1. Low bead breaking efficiency.
TO CHECK THE DISC INCLINATION:
Remove
the
protection.
Leave the bead breaker disc in rest position.
Position the electronic inclinometer on the disc. Make sure that the inclination from 50° to 51°.
Then press the joystick to change the disc inclination: it must be from 35 to 36°.
Summary of Contents for ATC 900
