CTC-CEN Service Manual 07-13 Rev.E
6
Electronic inclinometer:
Use the electronic level to adjust the bead breaker disc inclination
Kit Inverter firmware update # EAK0306G03A.
Use this kit to update directly on site the firmware of the Snap On Inverters instead to replace it
2.2 MPORTANT SAFETY INSTRUCTIONS
The units are CE or UL approved, but whenever using this equipment basic safety precautions should always be
followed, including the following:
1.
Read all instructions.
2.
Do not operate equipment with a damaged power cord or if the equipment has been damaged until it has been
examined by a qualified authorized service technician.
3.
If an extension cord is used, a cord with a current rating equal to or more than that of the machine should be
used. Cords rated for less current than the equipment may overheat. Care should be taken to arrange the cord
so that it will not be tripped over or pulled.
4.
Always unplug equipment from electrical outlet when not in use. Never use the cord to pull the plug from the
outlet. Grasp plug and pull to disconnect.
5.
To reduce the risk of fire, do not operate equipment in the vicinity of open containers of flammable liquids
(gasoline).
6.
Keep hair, loose fitting clothing, fingers and all parts of the body away from moving parts.
7.
Adequate ventilation should be provided when working on operating internal combustion engines.
8.
To reduce the risk of electric shock, do not use on wet surfaces or expose to rain.
9.
Do not hammer on or hit any part of the control box and portable control.
10.
Do not allow unauthorized personnel to operate the equipment.
11.
Use only as described in this manual. Use only manufacturer’s recommended attachments.
12.
Always securely lock the wheel before starting the operation.
13.
ALWAYS WEAR SAFETY GLASSES. Everyday eyeglasses only have impact resistant lenses, they are NOT
safety glasses.
14. Easy tire changer is for indoor use only.
2.3 ELECTRICAL SAFETY PRECAUTIONS
Make sure the tire changer is unplugged before disconnecting any wires in preparation for replacing any electric
mechanic components, cables or other items within the unit
CHAPTER 3
ELECTRIC, AND PNEUMATIC DIAGRAMS
Summary of Contents for ATC 900
