CTC-CEN Service Manual 07-13 Rev.E
83
Check if the bead breaker discs are damaged or worn out.
TO REPLACE THE BEAD BREAKER DISC
Loose the four screws that secure the disc to its support.
Remove the defective disc.
Install the new disc and secure it with the screws and Loctite.
Perform the bead breaker discs alignment calibration (
6.5).
8.7 BEAD BREAKER DISC BEARING# 1-06963A: CHECK AND REPLACEMENT
:
30’ Each one
:
Allen key 2,5, 3 and 4. Key of 19mm
:
Defective bad bead breaker disc bearing may cause the following malfunctions:
1.
Disc touches the rim during bead breaking operation.
2.
The bead breaker disc goes on the tire sidewall during bead breaking.
3.
The disc is broken.
TO CHECK THE BEAD BREAKER DISC BEARING:
Turn the machine off.
Check if the bead breaker disc show a lot of play.
TO REPLACE THE BEAD BREAKER DISC BEARING
Remove the red plastic cover.
Remove the bead breaker disc (
8.6).
Loose the lateral set screw with the 3mm allen key.
Loose the 12mm screw with the 19mm end key and remove the defective bearing from the arm.
Remove the defective bearing from the spacer.
Take the new bearing and install it on the spacer.
Summary of Contents for ATC 900
