CTC-CEN Service Manual 07-13 Rev.E
18
Take the Voltmeter and select it in VDC.
Position the Voltmeter probes on the connector terminals X3
coming from the CPU board inside of electric box.
Push the upper bead breaker arm by hand: whenever it will move
the multimeter display should show 24VDC.
If the multimeter display will not show any change of value, the
CPU board must be replaced.
TO REPLACE THE MOTOR:
Turn the machine off.
Remove the protection from the lower bead breaker arm.
Make sure that the bead breaker arm is unlocked
Disconnect the motor from the arm.
Turn the worm screw handily to remove the actuator from the arm.
Remove the cable from electric box.
Remove the cable from the chain.
Move the lower bead breaker arm all inward.
Fix the actuator to arm.
Insert the cable through the chain and connect it to the CPU
board.
Turn the machine on.
Summary of Contents for ATC 900
