CTC-CEN Service Manual 07-13 Rev.E
15
TO REPLACE THE SWITCH:
Check that the tabs for contacts on the new switch are correctly oriented.
Connect wires ends
FIRMLY
to the new switch terminals as shown in the appropriate electric diagram (
3.0).
Mount the switch to the electronic box
5.1.
Check if the machine works fine.
5.3 CENTERPOST MOTOR M3 CABLE: CHECK AND REPLACEMENT
:
1h
:
Medium screwdrivers, medium cross screwdrivers, 7mm tube type wrench, 4mm allen key, pliers, multimeter
:
Defective chuck motor cable may cause the following malfunction:
1. Low rotational torque.
2. Noisy
motor.
3. Motor damaging (burning).
TO CHECK THE CABLE:
Disconnect power supply from the wall.
Open the electric box.
Disconnect the wires
white, brown and
black from the Inverter.
Remove the front motor protection to access to the centerpost motor
Remove the motor terminals cover and disconnect all wires from
terminals.
Select the multimeter in Ohm and check if there is continuity
between ends of each wire.
Summary of Contents for ATC 900
