❏
2. Make a fuselage side by gluing together a
die-cut 1/8" [3.2mm] plywood
fuselage side
(FS)
, two 1/8" x 1/2" x 24" [3.2 x 12.7 x 610mm]
balsa sticks and the die-cut 1/8" [3.2mm]
plywood
stab saddle (SS)
. Use T-pins to hold
the parts over their location on the plan as you
proceed.
❏
3. After the glue from the previous step has
hardened, remove the fuselage side from the
plan. Make another fuselage side the same way.
After the glue dries, sand both assemblies flat
and even.
❏
4. Switching to the fuselage
bottom view
,
build the
fuselage top
over the plan from the
die-cut 1/8" [3.2mm] plywood
forward
and
aft
fuselage tops (FFT, AFT)
and two 1/8" x 1/2" x
24" [3.2 x 12.7 x 610mm] balsa sticks. Remove
the fuselage top from the plan, then sand flat
and even.
❏
5. Arrange both fuselage sides as shown in
the photo. Use a ballpoint pen to write “IN” on
the outward facing sides. Glue a die-cut 1/8"
[3.2mm] plywood
fuselage side doubler
(FSD)
to the
inside
of each fuse side.
❏
6. Glue the die-cut 1/8" [3.2mm] plywood
former F3D
to the front of die-cut 1/8" [3.2mm]
plywood
former F3
.
26
Summary of Contents for Dynaflite S.E.5a
Page 9: ...9 Die Drawing...
Page 10: ...10 Die Drawing...
