Hitachi Virtual Storage Platform F400, System Administrator Manual, Page: 60 / 368

Note:
■
Do not change the management file of the port number.
■
Close the management file of the port number while executing the
command for changing or initializing.
■
If the SVP software version of the registered storage system does not
support changing the port number, update the SVP software.
■
Port numbers 1 to 1023 are reserved for other application programs, so do
not use these numbers. If you use these numbers and encounter a
problem, change the number to 1024 or higher.
■
The following port numbers cannot be used for MAPPWebServer or
MAPPWebServerHttps:
2049, 4045, 6000
Procedure
1. Close all Device Manager - Storage Navigator sessions on the SVP.
2. Open the Windows command prompt as administrator on the SVP.
3. In the folder where the .bat file is located, execute the following command:
C:\MAPP\wk\Supervisor\MappIniSet>MappSetPortEdit.bat port-number-key-
name port-number
Note:
■
A space is required between
MappSetPortEdit.bat
and port-
number-key-name .
■
A space is required between port-number-key-name and port-number .
4. A service restart message box displays, followed by a completion message box.
Press any key to acknowledge the message and close the message box.
5. Close the Windows command prompt.
Initializing the SVP port number
You can initialize the SVP port settings and restore to the original status. After initializing
the port number, the SVP will be restarted.
To initialize the automatically assigned port number: See
Initializing and reassigning
automatically assigned port numbers (on page 62)
Before you begin
Remote desktop connection from the management client to SVP has been performed.
Procedure
1. Close all Device Manager - Storage Navigator sessions on the SVP.
2. Open the Windows command prompt on the SVP.
Initializing the SVP port number
Chapter 3: Configuring the storage system
System Administrator Guide for VSP Gx00 models and VSP Fx00 models 60