6 Optional functions
Optional functions through Remote control
SMGB0099 rev.0 - 12/2016
223
6
F6
– Automatic reset temperature for heating
This function is used to set automatic temperature reset in HEAT mode.
Setting condition
Setting temperature for automatic reset
17
17ºC
18
18ºC
· · ·
· · ·
21
21ºC (Factory setting)
· · ·
· · ·
29
29ºC
30
30ºC
F7
– Operation stoppage prevention by remote control switch operational error
?
N O T E
Operation is stopped by pressing the run/stop switch for 3 seconds.
F8
– Lock function for operation mode selection
This function is used to prevent changes to the operating mode.
F9
– Lock function for temperature setting
This function is used to prevent changes to the temperature setting.
FA
– Lock function for fan speed selection
This function is used to prevent changes to the fan speed.
Fb
– Lock function for swing louver operation
This function is used to prevent changes to automatic louver operations.
FC
– Cooling lower limit for setting temperature
This function is useful to set the temperature range in cooling mode. It enables the cooling range to be reduced for
configuration using the remote control.
An example is shown in the following figure:
Temperature range at cooling
(standard)
Min at c1ºC
Min at c10ºC
Possible to set temperature
by remote controller switch
Impossible to set temperature
by remote controller switch
Fd
– Heating upper limit for setting temperature
This function is used to define an upper temperature setting limit for the HEAT function. This function enables the heating
range to be reduced for configuration using the remote control.
An example is shown in the following figure:
Temperature range at heating
(standard)
Min at heating -1ºC
Min at heating -10ºC
Possible to set temperature
by remote controller switch
Impossible to set temperature
by remote controller switch
FE
– Not available
