Hitachi L200-002NFE2, Instruction Manual

Page: 276 / 304

ModBus Data Listing
Appendix B
B–40
C041 Overload level setting R/W Sets the overload signal level
between 0% and 200% (from
0 to two times the rated
current of the inverter)
1124h 04388 0 to
20000
0.01 %
C042 Frequency arrival
setting for acceleration R/W Sets the frequency arrival
setting threshold for the
output frequency during
acceleration, range is 0.0 to
400.0 Hz
1126h 04390 0 to 4000
*1
0.1 Hz
C043 Arrival frequency
setting for deceleration R/W Sets the frequency arrival
setting threshold for the
output frequency during
deceleration, range is 0.0 to
400.0 Hz
1128h 04392 0 to 4000 0.1 Hz
C044 PID deviation level
setting R/W Sets the allowable PID loop
error magnitude (absolute
value), SP - PV, range is 0.0 to
100%, resolution is 0.1%
1129h 04393 0 to 1000 0.1 %
C052 PID FBV function high
limit R/W When the PV exceeds this
value, the PID loop turns OFF
the PID Second Stage Output,
range is 0.0 to 100.0%
112Eh 04398 0 to 1000 0.1 %
C053 PID FBV function low
limit R/W When the PV goes below this
value, the PID loop turns ON
the PID Second Stage Output,
range is 0.0 to 100.0%
112Fh 04399 0 to 1000 0.1 %
C071 Communication speed
selection —
NOTE: These network
settings are not accessible to
ModBus. Use the inverter
keypad or digital operator to
edit. Refer to
“Network
Communication Settings”
on page 3–58
.
1138h 04408 — —
C072 Node allocation — 1139h 04409 — —
C074 Communication parity
selection — 113Bh 04411 — —
C075 Communication stop bit
selection — 113Ch 04412 — —
C076 Communication error
select — 113Dh 04413 — —
C077 Communication error
time-out — 113Eh 04414 — —
C078 Communication wait
time — 113Fh 04415 — —
“C” Group Intelligent Terminal Functions
Func.
Code
Name R/W Description
Network Data
Register
Range Res.
hex dec.