Hitachi HVM Navigator V03-06, User Manual, Page: 187 / 312

Migration procedures 3-91
HVM Navigator User's Guide - Migration
The same values as those set on the Storage Navigator Modular 2 CLI and
each storage device should be set for each of the above parameters in this
window. Otherwise, it’s possible that you cannot register migration WWPNs
through HVM Navigator.
The values which you should set for the parameters for Administration mode
are shown in Table 3-4: the values vary depending on the setting on the
Storage Navigator Modular 2 CLI. Also, the values which you should set for the
parameters for Password Protection and Account Authentication are shown in
Table 3-5: the values vary depending on the setting on each storage device as
well.
In addition, you can check Save password setting check box. When you check
the check box, the above parameters are saved after clicking OK button. So,
use the check box as needed.
Table 3-4 Setting for Administration mode
Setting for Administration Mode
on Storage Navigator Modular 2 CLI
Value which you should set in Storage Password Setting
window
Administration Mode check box Password text box
Enabled Checked Input the password
Disabled Unchecked Not available
Table 3-5 Setting for Password Protection and Account Authentication
Setting on Storage device
Value which you should set in Storage Password Setting window
Security Type column User ID Password
Password Protection Password Protection Input the User ID Input the password
Account Authentication Account Authentication Input the User ID Input the password
Not set Not used Not available Not available