Hioki LR8432-20, Instruction Manual

Page: 185 / 238

11.1 Troubleshooting
177
3
11
Ch
a
p
te
r 1
1
M
a
in
te
n
a
n
c
e
a
n
d
S
e
rv
ic
e
If abnormal operation occurs, check the following items.
Before Returning for Repair
Symptom Check Items
The display does
not appear when
you turn the power
on. • Is the power cord disconnected?
• Are connections made correctly?
• Is the battery pack installed correctly? Verify that the power
cord is connected prop-
erly (p.33).
Verify that the battery
pack is correctly installed
(p.28).
Keys do not work. • Is any key being held down?
• Is the key-lock state active?
(A message appears when a key is
pressed while key-lock is active.)
Verify key operation.
Cancel key-lock:
(Hold the
cursor
keys for three seconds)
Power does not
turn on. • A power protection component may
be damaged.
Customers should not at-
tempt to perform parts re-
placement and repair.
Contact your authorized
Hioki distributor or re-
seller for service.
A waveform does
not appear when
you press the
START/STOP key.
• Is the “Waiting for pre-trigger” mes-
sage displayed?
• Is the “Waiting for trigger” message
displayed?
• Is the waveform display color selec-
tion box selected ( )?
When pre-triggering is
enabled, triggering is ig-
nored until the pre-trigger
portion of the waveform
has been acquired. Re-
cording starts when a
trigger occurs.
No changes occur
in the displayed
waveform. • Is the measurement cable connected
correctly?
• Is the measurement range set prop-
erly?
Verify that the clamp sen-
sor or connection cable is
connected correctly
(p.34).
Data cannot be
saved to the re-
moval storage. • Is the removal storage inserted prop-
erly?
• Is the removal storage formatted?
• Is the remaining capacity of the
removal storage too low?
“Using a CF Card/USB
flash drive” (p.111)
If the cause is un-
known • Try performing a system reset (p.153).
• All settings are returned to their factory defaults.
“Appendix 5 List of Default Settings” (p. A11)