Hioki DSM-8104, Instruction Manual

Page: 38 / 132

28
5.1.2 Setting measuring mode
This meter has four measuring modes capable of measuring resistance, current, surface
resistivity and volume resistivity.
Set a desired measuring mode as follows.
(1) Key operation
(a) Press the [F2] MODE key for mode selection.
(NOTE: The modes are displayed on the Measured Value Display screen.)
(b) Each pressing of the [F2] MODE key sequentially selects resistance
measurement, current measurement, surface resistivity measurement and
volume resistivity measurement.
(2) Mode display
The individual measuring modes are displayed in the units displayed in the
measured value display section.
Measuring Mode Unit Indication
Resistance measurement Ω
Current measurement A
Surface resistivity measurement Ω
Rs
Volume resistivity measurement Ω
Rv
[Notice]
The actual unit for surface resistivity measurement is [ Ω ].
The actual unit for volume resistivity measurement is [ Ω ·cm].
5.1.3 Setting measuring voltage
(1) Keying
(a) Press the [F5] PSET key on the Regular Measurement screen or the
Sequential Measurement Monitoring screen shown in Fig. 5.3 to enter into
the Measuring Condition Setting mode.
(b) Input voltage after moving to “MES. V:” operating the cursor moving keys
([ ◄ ], [ ► ], [ ▲ ] and [ ▼ ]).
Voltage can be input by directly inputting on the numeric keys or by selecting
from the following preset values.
(c) The [F2] and [F3] keys perform the DOWN and UP functions respectively in
the Measuring Condition Setting mode, to sequentially change preset fixed
values.
The following fixed values are preset:
12 values: 0.1, 0.5, 1.0, 2.5, 5.0, 10, 25, 50, 100, 250, 500 and 1000