Hioki DSM-8104, Instruction Manual

Page: 128 / 132

118
and execute a command from an interface or execute self-calibration by keying the keys on
the panel periodically.
[Note]
When sequential measurement mode is set to ON, auto self-calibration function is not
performed even if the self-calibration function is set to ON. When performing sequential
measurement, periodically perform self-calibration by panel operation or by an interface
command.
10.4 Self-diagnosis Function
The self-diagnosis function consists of a function, by which self-diagnosis is executed by a
command by keying keys on the panel or by a command from an interface, and a function,
by which internal operations are always monitored in a normal operating condition.
See Paragraph 6.7.3 “Self-diagnosis” for the self-diagnosis function executed by keying.
In case malfunction is detected by a function that monitors internal operations, the meter
stops its operation and displays the following error message screen.
In this case, a component of the meter is faulty. Please contact the HIOKI sales office
near your location.
Error message:
“ERROR: xxx Call Service Center”
“xxx” in error codes have the following meanings.
Error Code Description
００１
Data in the memory is destroyed
００２
Memory write error.
００３
Memory read/write error.
００４
Poor calibration of current measuring unit.
００５
Poor calibration of A/D converter.
００６
Internal communication error with measuring
unit.
００７
Internal communication error with voltage
output unit.
００８ A/D data readout error.
００９
Power source frequency detection error.
０１０ Malfunction of voltage output unit.
[Note]
If meter operation is stopped by an error, pressing the [F3] SAVE key and
then the “- MAN.T” key sometimes resets meter operation to a normal operation
condition in about 60s.
Switching the power on again may return it to normal, but if an error persists, please
contact the nearest HIOKI office for repair.