Hioki DSM-8104, Instruction Manual

Page: 28 / 132

18
4.5 Display Screen
The display screen of the DSM-8104 is illustrated below.
“REMOTE”
When in the Remote mode (GP-IB or RS-232 mode), a side mark (“ ◄ ”) will be
displayed on the screen.
The Remote mode is not set when the side mark is not displayed.
“KEY LOCK”
When in the Key Lock mode, a side mark (“ ◄ ”) will be displayed on the screen.
The Key Lock mode is not set when the side mark is not displayed.
“INTERLOCK”
When the interlock function is on (enabled), a side mark (“ ◄ ”) will be displayed
on the screen.
The interlock function is off (disabled) when the side mark is not displayed.
“BUFF. FULL”
A side mark (“ ◄ ”) will be lit when the number of data groups saved by the
buffering function for 1000 data groups exceeds 1000. Measured data after
this mark is lit will be discarded without being stored in the buffer.
“CHARGE ON”
A side mark (“ ◄ ”) will be lit when the [CHARGE] terminal is usable. The
[CHARGE] terminal cannot be used when this mark is not lit.
“OPEN SET”
A side mark (“ ◄ ”) will be lit when open correction is executed. A contact
check can be carried out while this mark is displayed.
Executing a contact check when this mark is not displayed results in an error.
“MEAS COND”
A side mark (“•”) on the screen indicates that the meter is conducting
measurement.
“SHIFT”
A side mark (“ ► ”) on the screen indicates the status of the Shift key.
The Shift mode is not set while the side mark is not displayed.