Hioki DSM-8104, Instruction Manual

Page: 34 / 132

24
Table 5.2 Display of Measured Values
Classification Display Setting Procedure
Indication
type Unit indication
Exponential indication [F1]DISP
⇒
[F1]UNIT
[F1]DISP
⇒
[F2]EXP.
Number of
effective digits 2 to 5 columns [F1]DISP
⇒
[F3]FIG
Measuring
mode Ω : Resistance measurement
A: Current measurement
Ω Rs: Surface resistivity measurement
Ω Rv: Volume resistivity measurement
Press the [F2] MODE key to
sequentially select a desired
mode
Ω → A → Ω Rs → Ω Rv → Ω
Measured value - Reference value
Measured value - Reference value Deviation
value display
Reference value
X100%
Select [

MOD] and DEV
Select [

MOD] and PAR
Error display RANGE OVER: Overrange in current measurement*
*An [RANGE OVER] display indicates a measurement value which is beyond the preset
measurement range (resistance value of the measurement object is too low). An
[RANGE OVER] display during Auto Range will mean that the value is beyond the
measurable range.
Table 5.3 Meanings of Side Marks
Panel
Character
Side
Mark
Status
REMOTE
◄ In external remote mode
KEY LOCK
◄ In key lock mode
INTERLOCK
◄ Interlock in operation ([START] disabled)
BUF.FULL
◄ Data buffer is full
CHARGE ON
◄ “CHARGE” terminal can be used
OPEN SET
◄ Open correction already executed
MEAS COND
□ In measurement
SHIFT
► Key shift mode (Numeric and other keys can be input)
TRIG INT
MAN
EXT
►
►
►
Internal trigger is selected
Manual trigger is selected
External trigger is selected
COMP ON
► Comparison measurement is selected
The side mark flashes if a comparison result is NG.
V.CHK ON
► Voltage check is executed automatically
The side mark flashes if result of voltage check is NG.
C.CHK ON
► Contact check is executed automatically
The side mark flashes if result of contact check is NG.
NOTE 1
NOTE 1
NOTE 1
Note 1:
When a mark is flashing in case a result is NG, the mark does not go off till next
check is carried out or a decision is made.