Hioki DSM-8104, Instruction Manual

Page: 25 / 132

15
4.4 Command/Numeric Input Keys
The command/numeric input keys have the following functions:
７
COMP
８
DATA
９
MONI
SHIFT
4
E L E C
5
SETUP
6
L OC A L
E
M O D
1
O P E N
2
V. CH K
3
C.CHK
B S
PROG
L CD OF
.
０
L O C K MA N . T E N T ER
-
[SHIFT]: Shift
The key to change command/numeric input and the functions of the function
keys on the measurement screen.
The command/numeric input keys are set to the Command Input mode when the
[SHIFT] key is not pressed, set to the Numeric Input mode when the [SHIFT]
key is pressed.
Each pressing of the [SHIFT] key alternately changes the mode of the key.
When the SHIFT key is pressed, a side mark (“
◄ ”) will be displayed beside
“SHIFT” in the upper right of the screen.
[ENTER]: Enter
Pressing this key enters input results.
Exit after finishing setting the measurement screen and the setting screen by
pressing this key.
[LOCK]/”0”: Key lock
Press this key to prohibit key input.
Pressing this key prohibits operations of the keys other than the [STOP] and
[LOCK] keys.
Press the [LOCK] key again to cancel the key lock status.
When the keys are locked, a side mark (“
◄ ”) will be displayed beside “KEY
LOCK” in the upper left of the screen.
The key becomes a key for input of “0” when the [SHIFT] key is pressed and
the Numeric Input mode is set.
[LCDOF]/“.”: LCD off
The key to exit the display screen. The key shuts down screen display and
extinguishes the backlight.
Press any key to cancel when the display is turned off.
The key becomes a decimal point input key “.” in the Numeric Input mode.
[MAN.T]/“-”: Manual trigger
A trigger is generated and measurement is started when pressed while the
trigger mode is “MAN” (Manual Trigger mode).
When in the Numeric Input mode, the key will become a negative “-” polarity
input key.