![background image](http://html1.mh-extra.com/html/hilti/jaibot/jaibot_manual_2136282052.webp)
44
English
2230834
*2230834*
9
Transport and storage (Jaibot)
Storage
• Always unplug the supply cord before leaving the Jaibot unattended if it is to be left for longer than one
night.
• Store the Jaibot in a dry place, where it cannot be accessed by children or unauthorized persons.
• Always leave the Jaibot on a flat, level surface, not on an inclined plane.
• After prolonged transport or storage, check the Jaibot before use for damage.
Transport
• Stay well clear of suspended loads.
• Use only lifting equipment of adequate load-bearing capacity.
• Transport the Jaibot only in the transport box provided specifically for this purpose.
9.1
Loading the Jaibot into the transport box
The 4 side doors of the transport box permit access to the lashing eyes and the compartments while
the Jaibot is inside the transport box.
WARNING
Crush-injury hazard during loading and unloading.
There is a risk of crush injuries occurring when the
Jaibot is being loaded and unloaded and when the transport box is being crane-lifted.
▶
When loading the Jaibot and when crane-lifting the transport box, make sure that there is no-one in the
work zone or inside the slewing zone of the crane.
▶
Keep the work zone and the slewing zone free of obstacles and make sure that the entire zone is brightly
illuminated.
▶
Wear a hard hat and protective gloves.
1. Open the doors of the transport box.
2. Disengage the transport locks of the ramps and swing the ramps down into position.
3. Retract the telescopic mast and bring the Jaibot to the defined transport position.
4. Maneuver the Jaibot up the ramps and into the transport box.
Select the slow speed.
5. Switch the drilling robot off. → page 39
6. Select one of the following alternatives.
▶
Storage → Connect the Jaibot to the electricity supply and charge the batteries.
▶
Transport → Install the turnbuckles, on each side cross the lashing straps to diagonally opposite
points and strap the Jaibot into position.
7. Raise the ramps and secure them with the transport locks.
8. Close all compartments and close the transport box.
10
Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact
Hilti
Service.
10.1
Troubleshooting (Jaibot)
Trouble or fault
Possible cause
Action to be taken
Jaibot moving too slowly.
The batteries have discharged.
▶
Connect the Jaibot to the
electricity supply to recharge its
batteries.
Jaibot stops.
Fault in the motor management
system.
▶
Identify the fault code shown by
the motor management system
set low on the carriage. Contact
Hilti
service.
Summary of Contents for Jaibot
