Hilti Jaibot, Manual

Page: 47 / 264

*2230834*
2230834 English 39
Identification marking for the trades
Mark Meaning
Drilling series 1
Drilling series 2
Drilling series 3
Drilling series 4
Drilling series 5
Drilling series 6
Drilling series 7
Drilling series 8
7.1.11 Emergency off button
1. Press the emergency stop button on the wireless remote control or on the Jaibot to stop the Jaibot.
2. Reset the emergency stop button and activate the connection between the Jaibot and the wireless
remote control to restart the Jaibot.
3. To activate, press the green start button on the wireless remote control.
7.1.12 Switching off
1. Retract the telescopic mast.
2. Check that the rocker switch for drilling/moving is pushed up.
3. Select the "Switch system off" function on the tablet.
➥ The arm moves to the parked position and the system switches off.
4. As soon as the indicator lights go out, turn the key in the ignition switch to the 0 position.
7.1.13 Charging the Jaibot
1. Remove the charging cord from the side pocket of the service compartment and plug one end into the
charging connector in the carriage and the other end into the power outlet.
The Jaibot can be recharged off a suitable power source either when switched off or while it is in
operation.
2. For charging while in operation, make sure that the power cord is safely routed behind the Jaibot, at a
suitable height if necessary.
If an extension cord is used for charging, make sure that it is protected by a fuse of adequate
rating (16 A).
Keep the charging socket clean and dry.
7.1.14 Drill
7.1.14.1 General Information
For more information about drilling see the operating instructions supplied with the equipment and the
additional information about the product posted at: http://qr.hilti.com/r4695 .