Hillstone SG-6000-X10800, Hardware Reference Manual

Page: 80 / 89

71
Chapter 5 Hardware Maintenance and Replacement
|
Hillstone
Hillstone SG-6000 X-Series Hardware Reference Guide
5. Install a replacement module (see Installing a QSM ).
Note : If you do not want to install a new module, apply a blank plate over the slot to
avoid dust falling into the chassis.
Replacing an IOM
The following section takes IOM-16SFP as an example to describe how to replace an
IOM.
To replace an IOM, take the following steps:
1. Wear an electrostatic discharge (ESD) strap around your bare wrist and connect
the strap to an ESD point on the chassis. See
ESD Prevention .
2. Remove all the cables connected to the module.
3. Use a cross screwdriver to loosen IOM screws until they pop out.
4. Hold the screws and pull the IOM straight out of the chassis, as shown below.
Figure 5-6: Replacing an IOM (IOM-16SFP)
5. Put the removed module into an antistatic bag or on a flat antistatic table.
6. Install a replacement module (see Installing an IOM ).
Note : If you do not want to install a new module, apply a blank plate over the slot to
avoid dust falling into the chassis.
Replacing a Bypass Module
To replace a bypass module, take the following steps:
1. Wear an electrostatic discharge (ESD) strap around your bare wrist and connect
the strap to an ESD point on the chassis. See
ESD Prevention .
2. Remove all the cables connected to the module.
3. Use a cross screwdriver to loosen IOM screws until they pop out.
4. Hold the screws and pull the IOM straight out of the chassis, as shown below.