50
Chapter 3 Installation
|
Hillstone
Hillstone SG-6000 X-Series Hardware Reference Guide
1.
Wear an electrostatic discharge (ESD) strap around your bare wrist and connect
the strap to an ESD point on the chassis. See
2.
Take QSM out of its antistatic bag.
3.
Identify the slot of QSM.
4.
If the slot is covered with a blank plate, loose its screws with a cross
screwdriver and remove the plate.
5.
Position the QSM so that its front side faces you, and slide the QSM into the slot
until you feel resistant, as shown below.
Figure 3-12: Installing a QSM (QSM-20)
6.
Tighten the screws on the QSM with a cross screwdriver.
7.
To install more QSMs, repeat Step 2 to 6.
Note:
The tray is installed in each expansion slot at the factory, and you can install the
half width modules by taking the above steps. When installing the full width modules
(such as SSM-200, QSM-200, IOM- -200, IOM- and IOM-8SFP+),
you should remove the tray and install the modules by taking the above steps.
Installing an IOM
IOM has four types and should be installed in Slot1 to Slot10, but the IOM-
and IOM-8SFP+ module cannot be installed in the Slot7 expansion slot.
The following section takes IOM-16SFP as an example to describe the installation of
IOM.
To install an IOM, take the following steps:
1.
Wear an electrostatic discharge (ESD) strap around your bare wrist and connect
the strap to an ESD point on the chassis. See
2.
Take the IOM out of its antistatic bag.
3.
Identify the slot of IOM.
