24
Chapter 1 Product Profile
|
Hillstone
Hillstone SG-6000 X-Series Hardware Reference Guide
Table 1-17: SFP+ Optical Module Attributes
Attribute
Description
Short-haul
Multimode
Optical
Module
(850nm)
Short-haul
Multimode
Optical
Module
(850nm)
Medium-
haul
Single-
mode
Optical
Module
(1310nm)
Long-haul
Single-
mode
Optical
Module
(1550nm)
Ultra-long
Haul Single-
mode
Optical
Module
(1550nm)
Connector
LC
Fiber Type
50/125μm
multimode
fiber
62.5/125μm
multi-mode
fiber
9/125μm
single-
mode fiber
9/125μm
single-
mode fiber
9/125μm
single-mode
fiber
Maximum
Transmission
Distance
0.3km
(984.3ft)
0.033km
(108.3ft)
10km
40km
80km
Central
Wavelength
850nm
850
1310nm
1550nm
1550nm
Caution
: To avoid dust falling into the SFP+ socket, you should place a rubber dust
cap (originally in the accessory box) over the SFP+ port.
SD Card Slot
Hillstone SG-6000-X7180 has an SD card slot for SD storage card on the front panel.
SD card stores the data of the Network Behavior Control log messages. The highest
capacity for SD card on the device is 32GB.
To install an SD card, take the following steps:
1.
Ensure that the write protection switch is off so that it can be written.
2.
Face the front panel of the appliance.
3.
Insert the SD card with the metal contact side facing down and push it slightly
into the card slot. Do not push too hard with force to avoid damage to the slot
or the card.
4.
Find the seal label in the accessory box and stick it onto the SD card slot to
warn others not to eject the SD card freely.
Caution
: You need to back up the existing data in the SD card before inserting it into
the slot, as the system will automatically format the card in one minute.
To remove an SD card, take the following steps:
1.
Run the command
exec detach sd0
on the CLI interface.
2.
Face the front panel of the appliance.
