68
Chapter 5 Hardware Maintenance and Replacement
|
Hillstone
Hillstone SG-6000 X-Series Hardware Reference Guide
avoid dust falling into the chassis.
Replacing an SSM/IOM/QSM/Bypass
The following takes IOM as an example to introduce how to install an SSM, IOM, QSM
or Bypass. To replace an IOM, take the following steps:
1.
Wear an electrostatic discharge (ESD) strap around your bare wrist and connect
the strap to an ESD point on the chassis. See
2.
Use a cross screwdriver to loosen IOM screws until they pop out.
3.
Rotate the lever to outside till the lever head is out of the expansion slot.
4.
Hold the module with one hand and pull it straight out of the expansion slot
along the guide rail.
Figure 5-2: Replacing an IOM
5.
Put the removed module into an antistatic bag or on a flat antistatic table.
6.
Install a replacement module (see
Installing an SSM/IOM/QSM/Bypass
到引用源。
).
Note
: If you do not want to install a new module, apply a blank plate over the slot to
avoid dust falling into the chassis.
