51
Chapter 3 Installation
|
Hillstone
Hillstone SG-6000 X-Series Hardware Reference Guide
4.
If the slot is covered with a blank plate, loose its screws with a cross
screwdriver and remove the plate.
5.
Position the IOM so that its front side faces you, and slide the IOM into the slot
until you feel resistant, as shown below.
Figure 3-13: Installing an IOM (IOM-16SFP)
6.
Tighten the screws on the IOM with a cross screwdriver.
7.
To install more IOMs, repeat Step 2 to 6.
Note:
The tray is installed in each expansion slot at the factory, and you can install the
half width modules by taking the above steps. When installing the full width modules
(such as SSM-200, QSM-200, IOM- -200, IOM- and IOM-8SFP+),
you should remove the tray and install the modules by taking the above steps.
Installing a Bypass Module
Hillstone SG-6000-X7180 supports two types of bypass module: single-mode bypass
module (IOM-2SM-BE) and multi-mode bypass module (IOM-2MM-BE). The bypass
module is installed in Slot1 to Slot10.
To install a bypass module, take the following steps:
1.
Wear an electrostatic discharge (ESD) strap around your bare wrist and connect
the strap to an ESD point on the chassis. See
2.
Take the bypass module out of its antistatic bag.
3.
Identify the slot of bypass module.
4.
If the slot is covered with a blank plate, loose its screws with a cross
screwdriver and slide the plate out of the slot.
5.
Position the bypass module so that its front side faces you, and slide it into the
slot until you feel resistant, as shown below.
