25
Chapter 1 Product Profile
|
Hillstone
Hillstone SG-6000 X-Series Hardware Reference Guide
3.
Rip off the label stuck on the slot.
4.
Push the SD card slightly and it will pop out.
Note
: Hillstone recommends Kingston and SanDisk SD cards of 16GB and 32GB. To
ensure the storage writing speed, the SD card should have a speed of Class 4 at least.
CLR Button
The CLR button of SG-6000-X10800 is in the pinholes of two SCM modules, and the
CLR button of SG-6000-X7180 is in the pinhole of the front panel. The CLR button is
used to reset the appliance back to the factory default settings. You can restore
access to the appliance with this button if the login password is lost.
Warning
: Use this button carefully. Resetting the appliance clears all existing
configurations.
To restore the factory default settings of SG-6000-X10800, take the following steps:
1.
Press the CLR button in the pinhole of a SCM module, and press the CLR button
in the pinhole of another SCM module in five minutes.
2.
When the STA and ALM LEDs turn to constantly red, the appliance begins to
restore to the original factory settings.
3.
The system reboots after the default settings restored.
To restore the factory default settings of SG-6000-X7180, take the following steps:
1.
Turn off the power of the appliance.
2.
Press the CLR button in the pinhole and switch on the power supply
simultaneously.
3.
Keep pressing till the STA and ALM LEDs turn to constantly red, then stop
pressing. The appliance begins to restore to the original factory settings.
4.
The system reboots after the default settings restored.
Cooling System
The cooling system consists of two fan trays.
Each fan tray of SG-6000-X10800 has five fans. The fan trays are horizontally located
in the fan slots of the front panel. The fan trays can be replaced, see
