Hill-Rom® P500 Therapy Surface User Manual (158251 REV 3)
31
Bed Frames
WARNING:
The safe working load of the surface may be more than the safe
working load of the bed frame. Injury or equipment damage could
occur if you exceed the safe working load of the bed frame.
WARNING:
Do not use the P500 on a bed with siderail pads or extenders
installed in locations other than those recommended in the bed
product user manual. To do so could cause injury or equipment
damage.
WARNING:
It is the user’s responsibility to make sure the occupant is safe if
the surface is used on a frame
not
approved by Hill-Rom.
The unit can be used on the bed frames shown below. These bed frames
have been evaluated for fit and function with the P500 installed. For the
latest list of approved bed frames, contact Hill-Rom Technical Support.
For use on a bed frame
not
approved by Hill-Rom, evaluate the bed
frame with the surface installed to make sure it is safe for occupant use.
Bed Exit/Out of Bed Alarm
The P500 has an Out of Bed Alarm that when the alarm is set and the
occupant’s weight is no longer detected on the surface, the alarm comes
on. On bed frames that have their own Bed Exit Alarm System, we
recommend that you use the surface’s Out of Bed Alarm instead of the
frame’s Bed Exit Alarm System (see “Out of Bed Alarm” on page 18).
From Hill-Rom
100 Low Bed
Advanta™ 2 Bed
1000 Bed
CareAssist® Bed
80 Bed
CareAssist® ES Bed
70 Bed
Century Bed
Advance® Series Bed
Bed
Advanta™ Bed
Resident® LTC Bed
From Stryker
Go Bed® II
Secure® II Bed
S3 Bed
InTouch® Bed
