Hill-Rom DuraStar Series, Service Manual

Page: 87 / 165

4.8 DuraStar™ Fixed Height Stretcher Upper Frame
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 30 DuraStar™ Series Stretcher Service Manual (man268)
Replacement
1. Put the upper frame onto the base assembly so that the frame is in position,
and the holes align on the head end (B) and foot end weldments (F) (see
figure 4-13 on page 4-29).
2. Using the ratchet and the 1/4" socket, install the four bolts (A), two plates
(K), and nuts (C) that secure the upper frame to the head end weldment (B).
3. Using the ratchet and T25 Torx®
1
head bit, install the four screws (D) and
two foot end clips (E) that secure the upper frame to the foot end weldment
(F).
4. Using the torque wrench, torque the four nuts (C) to 65 + 10 in-lb (7.3 +
1.1 N·m).
Adjustment
1. Using the 1/4" Allen™
2
wrench, remove the screws (H) from one side of
the head column base weldment (I) and foot column base weldment (J) (see
figure 7 on page 4-31).
1. Torx® is a registered trademark of Textron, Inc.
2. Allen™ is a trademark of Industrial Fasteners, Inc.