HIKVISION DS-PHA20-M, User Manual, Page: 63 / 127

When the function is enabled, if the device is armed, the indicator will be on all the time. And if
the device is disarmed, the indicator will be off.
Note
Only -P model supports this function.
Prompt Fault When Arming
If the device applies EN standard, by default, the function is disabled. In this case, the device will
not prompt faults during the arming procedure.
Note
Only -P model supports this function.
Enable Early Alarm
If you enable the function, when the zone is armed and the zone is triggered, the alarm will be
triggered after the delay time.
Note
The early alarm will be taken effect only after the delayed zone is triggered.
Delay
When the early alarm function is enabled, you should set the delay time. The alarm will be
triggered after the configured delay time.
Fault Check
The system determines whether to check the faults listed on the page. The system will only check
the fault that is selected.
Click Configuration → System → System Options → Fault Check to enter the Advanced Settings
page.
Hybrid Security Control Panel User Manual
55