HIKVISION DS-PHA20-M, User Manual, Page: 44 / 127

7. Set the Wireless Supervision Time, and the system determines connection fault if the
disconnected duration of the device is longer than the configured value.
8. Click OK.
Note
After the sounder is configured, you can click Device Status → Sounder to view the sounder
status.
Output
If you want to the link the device with a relay output to output the alarm, set the output
parameters.
Steps
1. In the client software, select the device on the Device Management page and click , or enter
the device IP address in the address bar of the web browser and log in.
2. Click Configuration → Device Management → Relay to enter the Output page.
3. Click and the Output Settings window will pop up.
Figure 4-22 Output Settings
4. Edit the relay name and select a link event.
5. Enable LATCH PULSE or set the output delay time.
Note
If the relay has linked to the wireless output module, the wireless output module information
will be displayed in the Enroll Wireless Output Module area.
6. Check Event Type .
7. Check areas linked to the relay. (Zone and Manual event do not have this parameter.)
8. Select to enable Contact Status or not. (Only for Arm and Disarm.
Hybrid Security Control Panel User Manual
36